The gas that fills the envelope of a bulb. Incandescent bulbs over 40 watts are almost always filled with an inert gas, which is a gas that won't react with other materials, such as argon but, in higher performance applications, krypton or xenon. Bulbs under 40 watts most commonly have a vacuum fill but 40 watt bulbs may or may not have a gas fill. The purpose of using a gas fill is to increase the bulb's lifetime and efficiency. The weight of the gas(es) reduces tungsten evaporation and conserves heat which in turn increases efficiency. Heavier gases have greater effect and increasing fill pressure further increases said effects. Krypton and xenon are quite expensive compared to argon and thus, to decrease the amount required and to increase resilience, the gas filled envelope is much smaller.
Image: argon fill 1500w PS52 - 6.5" MOD (left) vacuum fill 25w A19 - 2" MOD (middle) xenon filled 60 watt T4 - 0.5" MOD (right)
A shaped piece of material seated between two surfaces as to shaped piece or ring of rubber or other material sealing the junction between two surfaces in an engine or other device." - dictionary.com
A general service lighting application is one that serves the purpose of providing light for general purposes such as a strip, troffer and wall pack fixture.
The current design, technology, performance level and/or cost basis of a particular product cycle. Example: "Each new generation of LED product tends to be cheaper with a smaller footprint and higher performance." Most commonly generations are only numbered when referring to multiple generations from the same manufacturer.
Germicidal bulbs are designed to eliminate microbes, and/or to create ozone. They emit specific wavelengths of ultraviolet (UV) that are effective at killing bacteria by destroying its DNA. While they do emit some visible light, it serves no purpose as they are not under any circumstances used for general service lighting applications.
There are two classifications of germicidal bulbs, high pressure and low pressure. The high pressure type resemble high intensity discharge bulbs and the low pressure type visibly resemble fluorescent and compact fluorescent bulbs, they even having the same bases and shapes and are thus often incorrectly referred to as being "fluorescent" but they are not since they have no phosphor coating. The mercury in germicidal bulbs and that in fluorescent bulbs both emit the same wavelengths but the phosphor inside fluorescent bulbs absorbs the harmful UV and then re-emits the energy as visible light.
All germicidal bulbs have clear envelopes made of fused silica (quartz glass) envelopes. Quartz is used because, unlike the glass used in general service fluorescent bulbs, it transmits the full range of UV. The wavelengths in the mercury emission spectrum of 185nm and shorter are sufficiently powerful to create ozone (O3) from the oxygen (O2) in the surrounding air. Ozone production is desirable in water purification applications. The most common type of germicidal bulbs however are used in applications that do not require the production of ozone and thus have a special coating applied to their envelope that blocks ozone creating wavelengths.
Note: The range and intensity of UV emitted by germicidal bulbs is harmful to both skin and eyes, and should not be used in any fixture or application that is not designed specifically for germicidal bulbs.